Injection Foam in Falls Church, VA

Monday, May 13th, 2019 by John LeVan

Challenge

This Falls Church, VA home was under-insulated and had walls that were drafty. We needed to find a way to insulate this home from the inside without disturbing the residents.

Solution

Comfenergy decided to remove the cedar siding and use injection foam from the outside of the home. We repaired broken siding and had the house re-painted. The result? Warm walls, nice looking house, and the customer was not disturbed by the process!

Project Summary

Energy Consultant: Mike Dowling

Installer: Marvin Galdemez

Siding removed and holes bored into wall to inject insulation foam.

Holes ready for foam.

Prior installation of foam from another vendor had failed... Not this time!

Carpenter removed this section of siding and we spray foamed it to assure a good seal.

House put back together and painted. Sweet little house in Falls Church, VA now with warm walls!

About the author

John LeVan

Partner

John LeVan is a Mechanical Engineer trained at Columbia University School of Engineering and Applied Science. John also has an advance degree in Operations Management from Cornell University.

Back to Previous Page Back to Case Studies

Injection Foam in Falls Church, VA

Challenge

Solution

Project Summary

About the author

our service area

We serve the following areas